Laser engraving machine maintenance guide

Laser engraving machine maintenance guide
First, the linear guide rail is filled with lubricating oil
The laser engraving machine uses a period of time, engraving, cutting the smoke generated by the dust, the dust has a corrosive effect on the guide rail, so the rail should be regularly maintained.
Turn off the laser engraving machine, clean the rails with a clean soft cloth, and then apply grease to the rails. After the oil is finished, let the sliders roll back and forth on the rails to ensure that the lubricant enters the inside of the slider. After the oil is finished, let the slider roll back and forth on the guide rail. At this time, the guide rail must be installed first. Be careful not to fix the rail when installing the guide rail. Install the fixing nails all the way, keep the level, and fix the belt and the slider. Then install the lens and dim the X to go to the way.

　　Second, the mirror |Focusing mirror wipe
Laser engraving machine|After using the laser cutting machine for a period of time, the smoke dust will adhere to the surface of the lens, affecting the engraving and cutting depth, and will also affect the engraving and cutting precision. Generally in a week or so (according to laser cutting machine |Frequency of use of the engraving machine) Clean three mirrors and one focusing mirror with absolute alcohol.

　　Third, the bearing oil
The laser cutting machine uses a large number of bearings. In order to ensure good cutting and engraving effects, some bearings need to be refueled regularly (except for oil-impregnated bearings). Wipe the floating soil on the bearing with a clean soft cloth, and use the needle tube to suck the oil into the needle tube. The needle is slowly injected into the bearing, and the bearing can be rotated slowly while oiling.

　　Fourth, the timing belt (Belt) elastic adjustment
There are several timing belts in the drive system of the laser cutting machine. If the timing belt is too loose, there will be ghosting of the engraved font. If the timing belt is too tight, the timing belt will wear. After using for a period of time, please adjust the tensioning screws of the timing belt to adjust the timing belt to the tightness, the engraving text does not appear ghost, and the laser engraving machine, laser cutting machine running noise is very low, or consult the manufacturer's technology. personnel.

　　Five, laser tube maintenance
The laser tube in the laser engraving machine is cooled by circulating water. After long-term use, there will be some white scale in the tube. We can add a small amount of vinegar in the circulating water, remove the water drain in the tube, and then use clean. The water circulates the inside of the laser tube so that the laser tube will be in optimal working condition and the life will be extended.